Power Save mode is used to improve efficiency at light load. The Power Save (PS) pin can be used to select different operation modes. Check out the Hookup Guide in the Documents section below to learn how to control the charging and regulator output. Note: When you are finished charging your battery, it is recommended that you remove the battery from the Powercell, since the charge will slowly drain without proper management. Note: This board does not have reverse polarity protection, so please be sure to recognize the polarity of your connections! The boost converter is based on the TPS61200 from TI and has solder jumper selectable 5V and 3.3V output, and an under voltage protection of 2.6V (which can be disabled via solder jumper on the back of the PCB). There is also an under-voltage lockout on the Powercell board which is tied to a solder jumper so that you can disable it if you like. Keep in mind, if you keep your battery connected to the Powercell, it is recommended that you disable the switching regulator (pull EN low) in order to prevent the battery from discharging and reaching the under voltage cutoff on the battery itself. We've also broken out the power-save and enable pins, so that you can have full control of the switching regulator. There are also two charge pins broken out (labeled 'charge'), so you can use another 5V power source to charge the batteries, if you don't have a micro-USB cable. The board comes with a JST connector for a single cell LiPo battery, a micro-USB connector for the 5V charge input, and selectable 3.3V and 5V output pins (labeled 'out'). The PowerCell board is a single cell LiPo boost converter (to 3.3V and 5V) and micro-USB charger in one.
0 Comments
10313 Wildflower Bouquet – CAD$79.99ġ0314 Dried Flower Centrepiece – 1 February 2023.Receive a free copy of 40630 Frodo & Gollum when you order the set.ġ0313 Wildflower Bouquet – 1 February 2023 Note: VIP early access from 5-7 March 2023. LEGO Icons 10316 Lord of the Rings: Rivendell – 5 March (VIP) / 8 March (General release) 76961 Jurassic Park Visitor Center: T.LEGO Jurassic Park 30th Anniversary – 1 June 2023
|